AsahiKASEI

Sports products and miscellaneous goods

Expanded polyethylene MEF is moldable, suited as a component material for sports gears, toys, sundries and etc.

Sports protector gear
Sports protector gear
Cold box
Cold box
Inner sock of shoes
Inner sock of shoes

Sports gears

① Lightweight

Expanded polyethylene MEF is lightweight.
MEF x30 (Density: 0.034g/cm3) is approximately half weight of Urethane foam (Density: 0.068g/cm3)

Lightweight

② Low wear and tear

Tensile Strength 3.0kgf/cm2 (x30 molding product, Test Method, JIS K6767)
Tensile Elongation 35% (x30 molding product, Test Method, JIS K6767). Compared with other foam products, MEF is resistant to cracking and chipping.

Low wear and tear

③ Excellent compressive recovery performance

MEF has excellent compressive recovery performance, 12% compression set (x30 Molding product, Test Method, JIS K6767), hence it is great for repeat use.

50% compression set

50% compression set

Note: All values shown in this table are given as typical
laboratory averages, intended to serve as approximate
guide and not as specifications.

④ Excellent wear-resistant property

MEF has excellent wear-resistant property and thus finished goods can be packed in direct contact with MEF, eliminating the need for a secondary packaging material such as PE plastics bags.

Wear volume comparing

Wear volume Comparing

Note: All values shown in this table are given as typical
laboratory averages, intended to serve as approximate
guide and not as specifications.

MEF is suited as a component material for sports gears.